Catalog pricing shown. Please Sign In to see your pricing.

Arcoaire AC Single Phase Split System Deluxe Single Stg 5 Ton 61k BTU 80Pct ULN Gas Furnace 080 MBH 14.5 SEER2

Arcoaire AC Single Phase Split System Deluxe Single Stg 5 Ton 61k BTU 80Pct ULN Gas Furnace 080 MBH 14.5 SEER2
Kit Includes BIP Gas Cock, PVC Ptrap Kit, Electrical Box, Switch, Receptical & Duplex Cover, whip 6' 3/4" 8GA, Disconnect, 50' Line Set 1/2" Insul, PVC Adapters/Fittings, No Vent Caps, 2" Plastic Pad, Furnace Leveler, 2H/2C Thermostat

This retail set contains

Vendor Name:
Arcoaire
URI Part Number:
Arcoaire AC Single Phase Split System Deluxe Single Stg 5 Ton 61k BTU 80Pct ULN Gas Furnace 080 MBH 14.5 SEER2
Shipping Weight (Lbs.):
200
Energy Star:
Not Energy Star Compliant
Heating Input (BTUH):
080 MBH Heat
Includes:
H4A6S60AKAWA, N80ESU0802120A, EAM4X61L24A, ACGKIT9
Nominal Capacity (BTUH):
60000
Cooling Efficiency (EER2):
12
Cooling Efficiency (SEER2):
14.5
System Indoor Type:
ULN Gas Furnace
System Outdoor Type:
Single Stage
System Coil Configuration:
Multi Position "A" Coil
Furnace Efficiency:
80
System Nominal Tons:
5.0 Ton
AHRI System Number:
208075861
A/C, Single Phase, Split ULN Gas Furnace Single Stage, Multi Position "A" Coil H4A6S/N80ESU/EAM4X

Air Conditioner Condenser
  • 80% AFUE
  • Flame roll-out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC and 115 VAC humidifier terminal
  • Electronic air cleaner terminal
  • Select sizes approved for twinning, refer to accessory kit listing
  • N80ESL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
  • Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
  • Adjustable heating blower OFF delay
  • Factory set blower ON delay
  • RPJ aluminized steel heat exchanger
  • High temperature limit control designed to prevent overheating
  • Direct ignition with Silicon Nitride igniter
  • One piece prepainted steel cabinet
  • In-shot burners
  • 33 1/3” (847mm) high, for ease of installation
  • Quarter turn knobs for easy door removal and secure attachment
  • Factory shipped for natural gas, convertible to propane with accessory kit
  • Four position - upflow/downflow/horizontal (left/right) installation
  • Three position inducer elbow capability
  • Through the casing flue pipe for counterflow applications
  • Common venting with other Category I appliances
  • Masonry chimney adapter available
  • Self diagnostics
  • Slide out blower assembly
Gas Furnace
  • Efficient multi-speed ECM blower motor
  • Variable-speed induced draft combustion motor
  • Single-stage gas valve
  • Natural Gas only, not convertible to Liquid Propane
  • 4 Way Multipoise
  • Stainless steel heat exchanger
  • Reliable direct gas ignition with silicon nitride ignitor
  • High temperature limit control helps prevent overheating
  • Solid, pre-painted steel cabinet with tight fit door latch system
  • Sound-reducing features: fully insulated cabinet with soft mounted blower and inducer motor
  • Compatible thermostat: heat/cool with humidity sensing
  • Heating capacity: 40,000 - 100,000 BTUh
Evaporator Coil
  • Corrosion resistant aluminum tube
  • Bolt-on TXV metering device factory installed on all models (equalizer tube brazed in)
  • TXV and manifold positioned to the side for easier cleaning
  • Innovative drain pan design for complete water removal
  • Two condensate drain connections (Additional two for horizontal installation)
  • 2-piece delta plate for easier removal and cleaning
  • Cabinet widths match flush with Arcoaire gas furnaces
  • Hemmed flanges for safer handling
  • Foil faced insulation
  • Non-sweat cabinet, even at extreme conditions
  • Cabinets meet or exceed 2% air leakage codes
  • Sturdy, 22 gauge, pre-painted steel cabinet
  • One or two UV light knock-outs provided on cabinet (depending on size)